Gaggenau gas hob VG 491 115F 90 cm steel finish

Cod. VG 491 115F

• 5 burners with a power of up to 17.8 kW
• Fully electronic flame regulation, on 12 levels
• Precise manufacturing of steel with a thickness of 3 mm
• Possible free-standing or flush-to-top installation
• Ultra-precise flame adjustment
• Electronic flame control with automatic re-ignition in case of shutdown
• Slow cooking function
• Solid grids with flat surface
• Perfect combination with all appliances of the Vario 400 series

Cooking zones
• 1 multiple crown wok burner (300 W - 5800 W), suitable for pans/pots up to Ø 32 cm
• 2 ultra-rapid double crown burners (165 W - 4000 W), suitable for pots of max Ø. 28 cm
• 2 double crown burners (165 W - 2000 W), suitable for pots of max Ø. 24 cm

Operation
• Knobs with luminous ring and silk-screen printing for cooking zones and power levels
• Switching on with a single gesture
• Fully electronic control with 12 levels for exact temperature regulation and slow cooking function
• All the comfort of automatic ignition
• Immediate ignition of the flame with a single gesture

Features
• Simmer function
• Three-part cast iron grill with flat surface
• Brass burners

Safety
• Electronic flame control with automatic re-ignition in case of accidental shutdown
• Residual heat indication
• Automatic safety switch-off

Assembly precautions
• Depending on the type of installation (free-standing or flush with the top, with or without cover), the position of the built-in niche and the knob may vary
• Align the knobs with the burners
• Always respect the drawings relating to the installation of the knobs. If the panel is thicker than 23 mm, provide a space on the rear side
• If multiple devices from the Vario 400 series are combined, it is necessary to use the VA 420 connecting element between the various devices. Depending on the type of installation, the corresponding connecting element must be provided
• The load-bearing capacity and stability, particularly in the case of thin worktops, must be supported by suitable substructures. Take into account the weight of the appliance and additional loads
• Additional instructions for flush installation: Installation is possible in stone, synthetic or solid wood surfaces. The thermal resistance and watertightness of the edges of the cut must be respected. Regarding other materials, please consult the manufacturer of the worktop
• The groove must be continuous and uniform, so as to guarantee the correct positioning of the appliance on the gasket. Do not use a discontinuous covering
• The width of the joint may vary due to dimensional tolerances of the combinations and the cutout on the worktop
• If you install multiple appliances in single niches, provide a space of at least 50 mm between the niches
• Special nozzles that can be ordered separately
• The electrical connection is essential for the operation of the appliance
• Air supply from above
• Assembly without intermediate shelf
• Provide a non-flammable and heat-resistant material for the rear wall and the slats
• Leave a minimum distance. of 30 cm between the top and surfaces sensitive to heat or apply thermal insulation
• Possibility of insertion in 90 cm bases
• With a total absorption greater than 11 kW it is necessary to comply with local regulations in regarding ventilation, size of the room and combination of extraction or recirculation hoods
• The minimum distance between the gas hob and the wall unit above it is 76 cm
• The minimum distance between the hob and the hood is indicated in the installation instructions of the extraction unit
• The combination with the VL 414 extraction center is not recommended due to the excessive distance between the central burner and the hood itself
• The appliance can be installed from above
• Appliance weight approx. 30 kg

Connection values
• Total gas absorption 17.8 kW
• Total electrical absorption 15.0 W
• Connection cable length 1.4 m with Schuko plug